Tuesday, September 27, 2011

IC39 - Hold it! Cell phone case

Over at Just Crafty Enough, the Iron Craft Challenge is Hold it.  We're to make a case or a bag.

I recently got a new phone.  It was a new model that had just came out and there aren't many accessories for it.  The only case that Best Buy had when I bought it was a black one.  I really was hoping to get something a little more fancy since I couldn't do that with my old phone. So I started thinking about making one, not one that is a pocket for my phone, but one that I can leave on while I'm using it.

So, I looked through my fabric stash, found a piece I liked and decided to try making my own.

First, I took a piece of paper and traced around my phone.  Then, I took a ruler and added two inches to the top and bottom and one inch (twice the thickness of my phone) to each side and drew a larger rectangle around the tracing I had made before.

IMG_1497

Next, cut out the rectangle and use it as a pattern to cut out the fabric.

Phone Case 2

Fold the long edges down 1/2 inch (the thickness of my phone) and sew both sides.
PhoneCase3
Next lay the phone in the center of the fabric, with the RIGHT side facing up. Bring the sides up and hold them there with a couple of rubber bands.
IMG_1502
Next fold up the ends to where you want them. Ideally, not covering the screen or any buttons, but in my case in order to stay on, it has to cover the buttons, but I can still keep it from covering the screen.

IMG_1504

Now, with needle and thread sew the corners and up the side a bit so that the bottom is closed. Then trim the excess fabric.
IMG_1505
Next, I took it off the phone, turned it right side out and tested the fit. It fit pretty well, so I did the same thing with the other end.

IMG_1507

Then I turned it right side out and checked the fit.

I was surprised by how easily it comes off and goes on.
I was also surprised that the buttons work ok even through the fabric (including the non hard ones).  So I don't need to cut a hole out of the bottom piece like I was originally planning to, unless I have problems remembering which one is which.  I'm planning on cutting holes out for the camera on the back and the top.

2 comments:

kat said...

Great idea!

waggonswest said...

I really like the way you figured out how to custom fit this.